Sony TV Mount KDP 65WS550 User Manual

Separating the Cabinet

(Models KP-65WS510, KDP-65WS550)

This flyer provides instructions on the separation of the projection TV cabinet.

IMPORTANT: This projection TV weighs over 300 pounds and has many delicate internal components.

Transportation, disassembly, and reassembly should be done by authorized Sony Dealers and Service Personnel ONLY.

Notes on Disassembly and Reassembly

The disassembly procedure requires at least 2 people.

You will need the following tools for this procedure: a screwdriver with either a philips or a 1/4" hex-head bit;

an open-end or socket 7/16" wrench.

The CRT projection assembly is exposed during the separation of the cabinet. Be careful to ensure that the top

portion of the cabinet does not contact the CRT projection assembly.

DISASSEMBLY

Using a screwdriver with a philips or a 1/4" hex-head bit,

unscrew the eight screws located on the rear panel of the

TV's cabinet.

Being careful not to contact the CRT projection

assembly, remove the back panel.

8 screws

CRT assembly

Disconnect the wire harness connector, located to

the right of the CRT assembly.

Using an open-end or socket 7/16" wrench, unfasten the

14 bolts located inside the cabinet, where the top and

bottom portion of the cabinet meet.

14 bolts

Being careful not to contact the CRT assembly, slide

the top portion of the cabinet back slightly.

Lift the top portion of the cabinet directly up. It should

separate easily.

IMPORTANT: Avoid contacting the

CRT assembly when separating or

reattaching the top and bottom

portions of the cabinet.

ATTENTION: The reassembly process is the reverse of the disassembly process.

IMPORTANT: When reassembling the cabinet, first fasten the two bolts on each side of the CRT

assembly (see step 3 ) to ensure that the top and bottom portions of the cabinet are aligned properly.

IMPORTANT: When reassembling the cabinet, make sure that the the wire harness is

reconnected (see step 4 ). If this is not done, the TV's Flash Focus feature will not function.

Printed in U.S.A.